Cantilever rack

Kragarmregal einseitig Höhe: 4.160 mm Nutztiefe: 1.200 mm / Länge: 4.000 mm

Used cantilever rack: screw system in hot-dip galvanized design

Scope of delivery:

4 rack uprights, height 4,160 mm with foot section, 1,200 mm usable depth

12 cantilevers with 1,200 mm usable depth, standard

Longitudinal and diagonal struts for 4,000 mm rack length (distance 1,300 mm)

Fastening material (screws, nuts and washers)

- (*Delivery time approx. 1 week)

- (*No damaged parts!)
- (*Reorder spare parts and extension possible at any time)

- (*Offer available in larger quantities: approx. 90 uprights in stock)
Chsdsmhhf Sjpfx Adqjd

Detailed description:

- Stable steel construction made of IPE profiles (screw system)

- Surface hot-dip galvanized

- Rack height 4,160 mm

- Load capacity per upright 2,250 kg

- Foot section and cantilever arms with 1,200 mm Usable depth
- Cantilever arms height adjustable in 100 mm increments
- 3 screwable cantilever arms per stand, standard (= 4 storage levels)
- Load capacity per cantilever arm 750 kg
- Including longitudinal and diagonal braces for 1,300 mm spacing
- Shelf length = 4,000 mm
- Including fastening material (without ground anchors)
- With assembly instructions and C4 load plates in accordance with DIN standard

- Expert advice by telephone
- Made in Germany
- Short delivery time
- On-site collection possible

Our cantilever racks are manufactured exclusively in Germany.
We offer reliable freight with registration before delivery.
The material is packed sensibly to enable easy unloading.

When installed outdoors, the load-bearing capacity is reduced by the wind and snow load.
The subsurface must be made of concrete, level and suitable for dowels and must be able to absorb the loads. The customer must check and ensure that the floor conditions and load-bearing capacity, as well as any official permits that may be required, are obtained.

The shelf supports must be anchored to the floor on site; anchoring to the wall is not necessary and is not recommended.

According to the trade association, it is recommended that the shelf supports on the top storage level have a projection of at least 500 mm above the top edge of the supports.

Annonsen har översatts automatiskt. Översättningsfel kan förekomma.