Restfukt i nästan alla plaster

Richard Hess MBV GmbH Hydro Tracer

The sample material is weighed and placed into a sample tray. The sample tray itself is part of an integrated reactor within the HydroTracer. A heater warms the sample – temperatures between 50 °C and 210 °C are freely selectable. The water evaporating from the sample reacts with the reagent in a cooled area and water is transformed into hydrogen. Other volatile substances will condense at the cooled surfaces within the vessel. The concentration of hydrogen gas is measured. It is a measure for the amount of water in the reactor.

The concentration of hydrogen is a measure of the sample humidity. The percentage of water of the sample is calculated by division with the sample weight.
The HydroTracer is controlled via a PC program. The program gives the user precise instructions so that operational errors are largely eliminated. The measurement is simple and requires only a few steps, each measurement is needed about 2 minutes of working time. The operation is supported by image-assisted program instructions. This method shortens the training period considerably. In principle, even an inexperienced user will be able to perform an accurate measurement.

Test Time:10 – 45 Minutes

Test Temperature:50 – 210°C (adjustable in 1°C steps)

Sample Weight:0.01 – 50 g

Reagent:CaH2-Pads / CaH2 granular form

Measuring Range:0.2 – 25 mg (absolute)0.0005 – 5% (relative)



Accuracy:Measuring error < 2%

Resolution:1 ppm (0.0001%)

0.1 – 0.8 mg (depending on measuring range)

Fslhcdwsk Nzvvsyjpg


Ambient Conditions:-10…40°C / 90% rH (not condensing)

Power Supply:100 – 240 VAC (50/60 Hz) / 1000 W

Weight:6.4 kg

Dimensions:290 x 180 x 260 mm (H x W x D)

Interface:USB

System Requirements:PC with min. WIN 9-10-11 SP 1 or later